PACK 30

 Return to the BUILD


“Now it is time to complete the assembly of the Front Right Seat for your model NISSAN GT-R (R35).”

 

Contents


Parts

Build


The Front Right Seat

Step 01

Push the four pegs on the back of the Seat Back into the matching locations on the Seat Back Panel.

You can see these four pegs in the lower half of both parts here:

Make sure when you fit these together to align the peg into the hole at the top of the seat (like we did with the front left seat).

The final result should look like this:

Secure the seat back together with four (4) GP screws:

Step 02

Push the four pins of the Seat Back Cover into the matching holes of the Seat Back Panel:

Step 03

Slot the seat back assembly between the upright parts of the Seat Base assembly (from the previous pack). Align the holes at the pivot point and secure both sides with two (2) KP screws:

Our seat should now look like this. As long as these screws are not too tight, you should be able to recline the seat back and forth a little:

Step 04

Retrieve the Interior Base assembly (from Pack 28).  Fit this seat assembly to the matching holes in the right side floor:

Step 05

Hold the seat assembly in place and secure it to the interior from below with four (4) GP screws:

Thoughts


This one was the same steps as Pack 28. Our interior is starting to look nice! Keep this assembly someplace safe for a while as it will not be needed again until Pack 56.

Next Up


Pack 31 – Frame: Rear Chassis

Leave a Reply

Your email address will not be published. Required fields are marked *