PACK 92

 Return to the BUILD


“Now you will assemble the Rear Spoiler and attach it to your model’s Trunk Lid.”

 

Contents


Parts

Build


The Rear Spoiler

Step 01

Push the two pins of the Rear Spoiler Brake Light into these matching holes at the center of the Rear Spoiler, as shown. This is a press-fit connection:

Step 02

Retrieve your Trunk Lid from the previous pack. Fit the Rear Spoiler Strut to this location on the Trunk Lid, aligning the locating peg and screw post as shown:

Step 03

While holding the Rear Spoiler Strut in position, secure it to the Trunk Lid from below with one (1) HM screw.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Step 04

Fit the two posts on the bottom of the Rear Spoiler into the matching holes of the Trunk Lid, making sure to align the center hole under the Rear Spoiler onto the top pin of the Rear Spoiler Strut, as shown:

Step 05

Secure the Rear Spoiler to the Trunk Lid from below with two (2) HM screws:

Thoughts


As most of these trunk part are metal, this assembly is quite heavy. It feels really nice!

Next Up


Pack 93 – Body: Trunk Lid Inner Trim

Leave a Reply

Your email address will not be published. Required fields are marked *